Peugeot 308 Key Fob replacement key for peugeot 308
Peugeot’s 308 is somewhat old-fashioned but it’s striking. It’s not the most luxurious vehicle in its class, but it is an enjoyable and comfortable driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. If the issue is persistent or intermittent the following tips will help.
Water Damage
If you accidentally drop your fob in a puddle or splash it with water while swimming, kayaking, canoeing, rafting or canyoning, it’s likely to suffer water damage. The best way to stop this from happening is to always keep it in a dry, dry bag when you’re going outdoors or doing activities in which the fob may be exposed to a lot of water.
It’s also essential to make sure that the fob has dried out prior to opening it up and then use it again. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid) it is a indication that it’s been submerged.
A wet circuit can cause the battery’s charge to drain or even explode. If you’re able, if you can, pull your 308 key fob out of the water body it was stuck in it, flip the button side down and shake it out as much water as possible before opening the case. After you open it, take out the battery, and then clean the circuit board using an alcohol-soaked cotton swab. 90-percent isopropyl alcohol.
Other reasons why your Peugeot 308 remote keyless entry system that you use to enter your home may stop working include the battery of your coin is dead problems with the receiver module signal interference, an electronic chip that is defective. If none of the above is the cause, you can reset the system by disconnecting 12 Volt battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar while warming up or cooling down the vehicle prior to entering. This feature is extremely helpful, especially during cold winter months. However, sometimes the remote stop system stops working due to a variety of reasons, like the battery of a coin that is dead.
The coin-shaped battery located inside the key fob could last between two and four months, depending on how often it is utilized, the place it was purchased, and how it is used. The date for use-by will be displayed on the packaging or in the user’s manual.
If the key fob stops working after exposure to water that is clean it is recommended to remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. In the event of exposure to soapy or salty water, the chip could be damaged and you’ll need to replace the key fob altogether.
If you’re not sure whether the battery is damaged You can test its voltage with an instrument connected to the plus and minus terminals. The voltage should be between 12-13 volts but if it is lower, then the battery needs to be replaced. Alternatively, you can try to reset your on-board computer by disconnecting the 12 volt battery for a short period of time, and then reconnecting it in reverse order (positive cable first and then negative). The engine should then start after this.
Faulty Receiver Module
If you’re not seeing the “Key Detected” message on your dashboard, then it’s possible the receiver module has discovered a problem. It’s the component that sends an alert to the car when the key fob is activated, it also acts as an immobiliser. It stops it from starting until the correct key is in place.
This could be due to a range of causes, such as water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip inside is damaged. In this instance it is necessary to take the unit apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. When the battery is dry you can attempt to test it again.
If the issue continues to persist, it is a good idea to visit an area Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the issue and repair it.
It is stressful to lose your Peugeot car key. A qualified auto locksmith will be able to solve the issue in a matter of minutes. They can program your vehicle and cut a brand new, functioning key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip inside the Peugeot 308 key fob plays an essential role in the remote control system. If the chip is damaged, you could experience difficulties starting your vehicle or receive a message saying “anti-theft”. In this situation the only option is to replace the key. Auto locksmiths who are professionals can provide this service within the shortest possible time.
The chip inside your peugeot 207 key fob not working (click through the up coming website page) 308’s key fob may become faulty for different reasons, including water damage, sweat or dirt. If your Peugeot 308 key fob is exposed to soapy water, you should clean it immediately. You can clean the electronic component with a paper towel soaked in isopropyl Alcohol. The battery should be allowed to completely dry.
Sometimes the key fob may be inoperable due to radio interference. This could be due to other devices use the same frequency as your Peugeot keyfob. It can also be caused by weather conditions or objects around the vehicle. If you experience this problem, it is best to visit the Peugeot dealership.
The peugeot 108 key cover Key Fob 207/308 is fragile and requires special care. It is not recommended to drop it or throw it around. If you lose something, try to find it as soon as you are able to. You can reset all on-board computers by disconnecting the battery that is 12 volts for a short period of time. Disconnect the negative cable before the positive.
