Peugeot 208 Key Replacement
Peugeot 208 key replacement is best left to professional auto locksmiths who have the proper tools and know-how. They can program and create keys faster and less expensive than dealers.
A dead battery for your coin is the most likely cause the reason your key-fob stops locking or unlocking the doors. There are other reasons for the key to be malfunctioning.
Dead Coin Battery
A dead battery can stop your Peugeot 208 from locking and unlocking, as well as stopping it from starting the engine. If this is the case, you’ll need to make use of the backup starting procedure which is explained in your vehicle’s owner manual.
Another reason why your 208 might not start is that the spark plugs have been damaged. The spark plugs are responsible for instigating the fuel that ignites the engine. However they are limited in their life span. If they are not used enough and they fail, they’ll eventually die.
There is an easy solution to this issue. Check the voltage of your battery with a multimeter. If the voltage is lower than 11,5 volts then it’s time to replace it. If the battery has corroded it is essential to clean its contacts. This can be done by lifting the rubber covers that protect the two terminals on the battery and using a wire brush to remove any corroded areas of the battery. You should then reconnect the cables for the positive and negative poles.
Water Damage
If your 208 doesn’t start and the battery hasn’t failed, you should check the spark plugs. It could be that they are overly dirty, causing them to not to spark. The spark plugs can be cleaned in an workshop.
Peugeot cars are equipped with a key with a transponder compatible with the immobiliser. This ensures that only the right key can turn the engine. If the chip inside the Peugeot key is damaged, it won’t send the proper signal to the vehicle.
This is a typical issue that is often caused by water damage. This is particularly common in colder climates where the vehicle could have been exposed to rain or snow. If this is the case, get in touch with a reputable locksmith who will have all of the tools and equipment needed to reprogram the new key. They also have the latest technology and equipment needed to create the peugeot boxer van replacement key 208 smart key. The process shouldn’t take more than 15 minutes.
Contacts to the battery are not working properly.
Peugeot changed from the carbon-encased transponder chips and introduced a new type of chip that uses electronic components on circuit boards. The new system is fantastic when it’s new, but the circuit boards deteriorate over time and stop working properly.
This can stop the immobiliser from working, so your vehicle will not start. If this is the case it’s a good idea to seek out a peugeot new key specialist or locksmith.
Another common issue is when the battery in the key fob gets depleted, which causes the blade of the key to stop getting into the lock. A car locksmith can replace the battery and cut a new blade for you, it’s normally a quick fix.
Faulty Receiver Module
It could be that the receiver module is defective in the event that your peugeot 108 key cover key fob fails to function after being dropped on the floor, exposed to a stormy rainstorm, or accidentally washed. The receiver module is responsible for transmitting radio frequencies to the onboard computer that controls the central locking system of your Peugeot vehicle.
The key fob itself has rubber seals that block water from getting to the electronic chip inside. Water can damage the chip when exposed to water for a prolonged period of period of. The high salt content of the ocean water or pool could cause damage to the key fob, especially if it is submerged.
The module will need to be replaced if your Peugeot spare key is no longer working. This can only be completed by an experienced auto locksmith or Peugeot specialist. As opposed to other cars, Peugeot keys are protected by an immobilizer that is unique and requires the correct coding in order to start the engine. This is the reason that you should only trust the Peugeot locksmith to design and program the replacement.
Computer malfunctioning on-board
The on-board computer in your Peugeot is responsible for various systems inside your car, including power windows and airbags. The on-board computer will display an error code when something goes wrong. The code is stored within the system and will stay there until the issue is fixed. Most often, this involves replacing the onboard computer.
One of the main causes of the airbag light turning on is the loose or corroded connections within the airbag sensor. This could be due to wear and tear, ageing or exposure to moisture and salt. This issue must be addressed as soon you can, because an airbag that’s malfunctioning could be dangerous in case of an accident.
If your Peugeot is showing a card not detected error, then the key battery inside the key fob could be weak or dead. This prevents the key fob from sending a signal that disarms your vehicle’s standard immobilizer. You can test this by pressing the unlock button on the key fob and then trying to start your vehicle. If this does not work, the key battery needs to be replaced.
