Peugeot 308 Key Fob Replacement
Peugeot’s 308 may be catching on a little however it’s still eye-catching. It’s not the most luxurious car in its class but an Ford Focus or Volkswagen Golf will protect you from surface imperfections – but it’s a relaxing and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 3008 key 308 key fobs. Whether the problem is constant or intermittent the following suggestions should aid.
Water Damage
If you accidentally drop your key fob in the puddle, or it gets wet while kayaking, canoeing or rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry bag whenever you are outdoors or engage in activities that expose it to a lot of water.
You’ll also want to ensure that the fob is dry prior to opening it and using it again. If you detect any smells emanating from the fob like an industrial-like smell or a sour taste like windshield washer fluid, this is another indication that it’s been submerged in water.
A circuit board that’s wet can cause the battery’s charge to drop its charge, or even explode. If you can get the 308 keyfob from the water you need to turn the button side up and shake as much water as you can before opening the casing. Take the battery out, and then wipe the circuit board clean with a cotton swab, which has been dipped in 90-percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not work include a dead battery in the coin-cell or receiver module malfunction signal interference, or a faulty chip. If none of the above are the problem it is possible to reset the system by removing the 12 Volt battery from the vehicle for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to getting in. This feature is extremely beneficial, especially during cold winter months. Remote start systems can cease to function for a variety reasons, such as the battery being dead.
The coin-shaped battery that is within the key fob may last between two and four years depending on the frequency with which it is used, where it was purchased, and how it is utilized. The date of use will be printed on the package or mentioned in the user manual.
If the key fob is not functioning after exposure to water that is clean it is recommended to remove the battery, clean the electronic chip using a paper towel and isopropyl ethanol, then dry it completely before replacing it. If exposed to soapy or salty water, the chip may be damaged and you’ll require replacing the key fob completely.
If you’re not sure if the battery is defective, you can check its voltage with a multimeter connected to both the terminals for plus and minus. If the voltage is lower than 12-13 volts then you must replace the battery. If you want to, you can attempt to reset the onboard computer by disconnecting the 12 volt battery for a few minutes and reconnecting it in reverse order (positive cable first, then negative). The engine should then start.
Faulty Receiver Module
If you’re not getting the “Key Detected” message on your dashboard, it’s possible that the receiver module has created a fault. It is the part that transmits an alert when the key fob turns on. It also functions as an alarm and prevents the vehicle from starting without the correct key.
It could be due to various causes, such as water damage or just ageing. If your peugeot 308 key (simply click the following web site) fob has been exposed dirty tap water, as in the electronic chip located on the inside will be damaged. In this situation, you’ll have to remove it and thoroughly clean it with isopropyl or an electronic cleaner. Once the battery has dried, you can try again.
If the issue isn’t resolved, it’s probably a good idea to visit a local Peugeot specialist or locksmith. They will be able to make use of a diagnostic device to assist in identifying the problem and repair it for you.
The loss of your Peugeot keys to your car is an incredibly stressful experience. However, a reputable auto locksmith can solve the issue in just a few minutes. They can program your car and cut a new working key for you. Find locksmiths near you.
Faulty Electronic Chip
The chip inside your Peugeot 308 key fob is an important component of the remote control system. If the chip is damaged, you may be unable to start your car or receive a message stating “anti-theft”. If this occurs, the only solution to fix the problem is to replace the key. Professional auto locksmiths are able to provide this fastest possible time.
The chip inside the chip of your Peugeot 308 key fob can fail due to sweat, water damage dirt, or other causes. If your Peugeot 308 key fob has been exposed to soapy water, cleanse it immediately. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. Then, you need to allow the battery to dry completely.
Radio interference can cause a key fob to stop functioning. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. This can be caused by bad conditions or objects near to the vehicle. It is recommended that you visit a Peugeot dealer if you encounter this problem.
The Peugeot 207/308 Key Fob is very delicate and requires special care. It is imperative not to throw or drop the key fob. If you lose something, try to locate it as soon as possible. You can reset all on-board computers by disconnecting the battery that is 12 volts for a short period of time. Be sure to disconnect the negative cable first, and then the positive.
